ULTRA-FLOW’s Professional team designs and installs lubrication systems which is why we are the preferred installer of Lincoln products with 30 years of experience.
Installing an automatic lubrication system in your machine can be a complex and challenging task, depending on the type and size of your machine, the number and location of the lubrication points, and the type of lubricant you use.
However, there are some general steps that you can follow to prepare and install an automatic lubrication system in your machine.
- First, you need to choose the right type of automatic lubrication system for your machine Designed for your application.
- Second, you need to clean the lubrication point and remove the grease fitting.
- You also need to apply thread sealant to all connecting parts and screw in the reducer.
- You should pre-lubricate the lubrication point and the connecting parts and prefill the grease lines if applicable. You should use the same lubricant as in the lubrication system.
- Third, you need to mount the pump and the metering device in a suitable location on your machine.
- You should follow the manufacturer’s instructions and specifications for mounting and wiring the pump and the metering device. You should also connect the power supply and the controller to the pump and the metering device.
- Fourth, you need to run the tubing/hose from the pump to the metering device and from the metering device to the lubrication points.
- Fifth, you need to set up the AUTOLUBE controller and program the lubrication cycle.
- you should follow the ULTRA-FLOW AUTOLUBE manufacturer’s instructions and specifications for setting up and programming the controller.
- You should also test the system and check for any leaks or malfunctions.